Table of Contents
What epoxy is gas resistant?
Loctite® Epoxy Weld does not shrink and is resistant to most shop fluids such as water, diesel fuel, gasoline, antifreeze, hydraulic fluid, motor oil and transmission fluids.
What kind of sealant can I use on a gas tank?
POR-15 Fuel Tank Sealer is a high-tech sealer impervious to all fuels, including the new Stage II fuels which have a higher alcohol content, and additives. It has superior strength and fuel resistance. POR-15 Fuel Tank Sealer stops rust, corrosion, and fuel leaks.
Can you use epoxy on gas tank?
Because the epoxy is clay-like consistency, fuel (or other liquids) can’t seep through it or around it. Once cured, the epoxy can withstand 300-degrees and 900 psi of pressure, so it will be perfect for your leaky gas tank.
Is Flex Seal gas resistant?
No, Flex Seal is not resistant against a corrosive flammable like gas or oil. It is strongly recommended that you do not attempt to use Flex Seal Liquid™ on a gas tank. Don’t be deceived by the fact that it may not ignite or leak through right away.
Will silicone seal a gas tank?
Silicone sealants are not recommended for use in a gasoline environment. The gasoline will attack the product.
What is the best gasket material for gasoline?
Nitrile
The best fuel resistant gasket material for gasoline is Nitrile (Buna-N), a closed-cell sponge rubber material that provides excellent gasket material for sealing applications that require resistance to gasoline, oil, fuels, as well as solvents, hydraulic fluids, and mineral and vegetable oils.
How do you dry out a gas tank after coating?
Remove all stops and insert a compressor air line, with pressure set at 1-5 psi (keep air line 2″ or more away from the coated surface to prevent thinning coating). Tank should be completely dry within 48 hours at 60°F or warmer. Cured coating should be slightly rubbery with no odor before filling tank with gas.
What is the best gas tank sealer kit?
Eastwood’s exclusive gas tank sealer kits have nearly everything you need to clean a rusty, old, varnished gas tank of all the fuel residue and gunk, and seal it with a virtually impervious internal coating. If you are careful, you can even use it to coat the inside of a motorcycle fuel tank without effecting the paint job on the outside.
Can you use sealer on a motorcycle fuel tank?
If you are careful, you can even use it to coat the inside of a motorcycle fuel tank without effecting the paint job on the outside. One kit seal tanks up to 5 gallons, and a few additional pints of sealer are all you need for larger tanks.
How do I know if my tank is properly coated?
A properly coated tank should have a uniform bright white coating of sealer free of any puddles. Some excess should remain. Let tank stand for 8-10 minutes with fill neck or sending unit open, then close openings and slowly rotate tank allowing excess to re-coat all surfaces.