Table of Contents
Do infrared heaters have a thermostat?
Heat Storm Control Module (Thermostat) – Some infrared heaters do not have thermostats. Other low quality infrared heaters only offer mechanical thermostats for reaching a desired room temperature. Mechanical Thermostats are inaccurate, some- times up to 5 degrees Fahrenheit.
Do you plug in infrared heaters?
You don’t have to decide right away though. You might decide to simply plug in the panels initially, and then when you realise how well they work and are completely sold on their benefits, you can hardwire them in.
Can I leave infrared heater on all the time?
In general, infrared heaters are safe to leave on overnight. They are not temperamental, and any modern heater worth its salt has safety shut-off switches in-case it falls over or gets too hot. That said, you should still be careful if you’re leaving one on while you’re asleep or out.
Is radiant and infrared the same?
Infrared heaters and radiant heaters are the exact same thing. The word “radiant” indicates that the heat is generated with radiation, whereas “infrared” just specifies which kind of radiation is used.
Does an infrared heater need a dedicated circuit?
Space heaters can range from 400 to 1500 watts, but a good rule of thumb is that the maximum watts per outlet should never exceed 1500 watts. In other words, yes, your 1500-watt heater needs its own circuit.
Where should infrared heaters be placed?
For a completely unhindered spread of heat, ceiling mounting your infrared panels is the way to go. Pointing your infrared panel down toward the floor ensures that living levels are always comfortably heated and all of the warmth created will be absorbed and re-emitted by the floor, walls and furniture.
Are infrared heaters directional?
Infrared radiation is a direct heating method, which travels from the source until it is absorbed by a solid object. However, the direct nature of infrared radiation means that it also has to be directed toward the right place.
How close can you sit to an infrared heater?
How close to objects can an Infrared panel be placed? To allow the panels to operate at the right temperature and unobstructed, our Instructions call for no objects to be placed within 400mm of the front of the panel and not within 200mm of the sides of the panel.
How to install an infrared thermostat?
Plug-in thermostat: The plug of the infrared heating panel will be plugged into the thermostat, which will then be plugged into the socket. The advantage of this variant is that the thermostat can be set up easily and quickly without hiring an electrician. Also, the infrared heater can easily be removed from the wall since no wiring has been done.
How do you wire an infrared heater to electricity?
2. Infrared heater with thermostat wired to electricity directly: Here, the infrared heater is wired directly to the electricity via the thermostat. Again, there is the choice between a remote control thermostat with a receiver or a simple thermostat, which is permanently installed on the wall.
What is the ANSI code for low intensity infrared heaters?
This is quoted from the Standard for Gas-Fired Low-Intensity Infrared Heaters (ANSI Z83.20/CSA 2.34) and the National Fuel Gas Code (ANSI Z223.1/NFPA 54). ANSI Z83.20/CSA 2.34 further states ”… and that such signs must either be posted adjacent to the heater thermostat or in the absence of such thermostat in a conspicuous location.”
What are the disadvantages of infrared thermostats?
A disadvantage is that the infrared heating panel can only be connected by an electrician and cannot be easily removed from the wall e.g when moving. This variant will usually be used for ceiling mounting since there is no socket to plug into. 3. Integrated thermostat receiver: Keeps all options open.