Table of Contents
Is there a standard height for shower valve?
For shower-only controls, between 36 and 48 inches from the floor is common. Employ your helper to hold the fixture at an estimated height and then see if it’s a comfortable reach for all users.
Are all shower valve bodies the same?
First, you absolutely CANNOT mix manufacturers on trim and rough-in valves. In fact, even within one manufacturer, they have many valves and the trims are not interchangeable. Shower sets are not always sold as separate trim and rough. In hardware stores and home centers they are almost always sold aa a complete set.
How far out should a shower valve be installed?
Your goal is to center the shower valve between studs 12 inches apart. A little mark at the midpoint of the plates, in line with where you expect the faucet and shower valve to be, helps for the next stage of this project. Next, mark 6 inches on either side of the midpoint.
What is the standard height of a tub faucet?
The tub spout will generally be located 4 inches above the rim of the tub. In a shower only unit, the faucet is placed higher at 48 inches off the floor. The shower head normally is located 72 to 80 inches above the finished floor.
How far back do you set a shower valve?
wall position, including tile (2-1/16″ [52mm]). The center line of the supply and discharge piping should be a maximum of 2-3/16″ (56mm) and a minimum of 1-7/16″ (37mm) behind the finished wall surface.
What shower valves are universal?
Shower valves are not universal and you cannot mix manufacturers when it comes to trim and rough-in valves. Besides that, one manufacturer will have different valve sizes and types which may also not be universal and interchangeable with each other. Luckily, shower sets are always sold as a complete set.
Is there a universal shower cartridge?
The Delta MultiChoice Universal Valve gives you the flexibility to upgrade the style and functionality of your shower without altering the plumbing behind the wall.
What is the standard height of a bathtub faucet?
What is the correct height to install a shower valve?
What Height Should a Shower Valve and Spout Be Set At? Considerations Before Installation. There are a few factors you should consider before installing a shower valve and head. Standard Shower Height. Generally, it’s recommended that shower valves be installed around 38 to 45 inches above ground. Popular Showerheads and Heights. Showerhead Accessory Height.
What is the standard height for a shower curb?
The Standard Full Height Curb height is about 4″ tall. This curb height works well with both shower doors and curtains. All curbs have a slope back into the shower area and the shower area has a 1/4” per foot slope towards the drain.
What is the standard height for a shower fixture?
Determine where the fixtures will be installed before you begin to avoid mistakes. Mark these locations with a pencil or a piece of tape. Standard shower faucet heights are usually from 45 to 48 inches, tub faucet heights are between 24 and 28 inches, and a standard shower head usually ranges from 72 to 78 inches high.
What is the standard height for a shower handle?
Standard height for the shower valve — the handle that turns the shower on — can be roughly waist high, 36 inches above the shower floor, or as high as 48 inches.