How do you get a stuck watch back off?
Pour a little acetone (nail varnish remover) into the socket and leave it for a minute or so. Empty out the excess acetone back into the cap of the bottle, attach the socket back on the wrench and give the case back a tap with a rubber mallet or something that will give it a bit of force but not mark it. Job done.
How do you take off the back of a watch case?
In this case, simply flip the watch over, grip it in one hand by the watch strap, and hold the friction ball against the case back with your other hand. Apply some pressure and rotate the ball counter-clockwise – if the case back is loose enough, it should unscrew fairly easily.
How do you remove watch back without notches without tools?
Using a Rubber Ball on a Screw-Back Watch. Purchase a soft, mashable rubber ball. Rubber balls often have enough grip to pry off watch backings. Choose a rubberized ball that is both squishy and tacky so it can latch onto your watch’s back.
How do you use a back press on a watch?
To use a back press select a die that will support the whole of the watch face and postion this on the bottom pin of the back press. Select another die that is approximately the same size as the watch case back and screw this on to the bottom of the part of the back press which can be screwed down. Click on image to enlarge.
How do I replace the case back on my watch?
When replacing the case back be sure that the indent on the cover lines with the winder. Click on image to enlarge. Step 2. With the case lined up with the back, push down on the watch case back using both thumbs to apply even pressure to the case edge, making sure that one side doesn’t get pushed further in than the other.
Why won’t my watch case back click in?
Some case backs are tight and won’t click in easily. The best way to deal with this is to place the watch face down on a flat protected surface – a mouse mat is ideal – and position a small, flat object, such as a piece of wood, across the back of the case and press down to try to give even pressure across the whole of the case back.
How do I tighten the back of my watch?
Slowly tighten the back press until the back clicks into position. Sometimes you will feel a slight click as the case closes, but often the case will close with out any sensation, so check carefully to make sure that you don’t over tighten the vice and damage the watch.
https://www.youtube.com/watch?v=nUVK54QigPE