Table of Contents
What do I need to know before drilling into concrete?
Measure and mark the spot on the concrete where you want to drill a hole. Check to be sure there is no infrastructure behind the concrete that might be damaged in the drilling. Check for water pipes, electrical wiring, or ductwork.
Is it safe to drill into a concrete wall?
You can, in fact, drill a hole in a concrete interior feature wall armed with nothing more than your trusty rotary drill and a masonry bit—so long as you take care to not burn out the motor of the drill or demolish the bits.
Why can’t I drill through my concrete wall?
The most common reason a drill won’t penetrate a wall at all is because the drill is spinning in the wrong direction. If the drill bit enters the wall and then hits resistance, the typical cause is a metal plate or masonry obstruction.
How do you hang things on a concrete wall?
Summary
- Mark the spot where you want to hang your photo.
- Place the drill bit over the mark and drill into the wall. Make sure to drill in straight.
- Tap your anchor into the hole until flush with the wall.
- Secure the screw into the anchor with a little space left over.
- Hang your photo.
Is it OK to drill into basement concrete wall?
Things You’ll Need Block or concrete basement walls create a challenge for homeowners who want or need to attach materials or fixtures to them. It is not difficult to drill into these walls, but it does take a special drill. A rotary hammer drill is used to make holes in block and concrete.
What kind of drill bit do I use for concrete?
masonry bits
Drill bits that can drill through concrete are called masonry bits. They are also good for drilling through brick and stone. Drill bits with a tungsten carbide tip are the strongest; when it comes to solid concrete, the sharper the better. Masonry bits cut holes through concrete in two steps.
Can you put nails in concrete walls?
Concrete nails are made of high-carbon hardened steel and have fluted shafts that help them sink into the concrete. You can also use masonry nails, which have a square cross-section and are tapered from the head to the tip. Masonry nails are cheaper than concrete nails and are less likely to break or bend.
How do you hang something on concrete?
Simply drill a hole into the concrete, hold the fixture you’re fastening over the hole, then use a hammer to tap the anchor into the hole. As you drive in the pin, the sleeve expands outward, trapping the anchor in the hole.
Can you drill a hole in a concrete interior wall?
You can, in fact, drill a hole in a concrete interior feature wall armed with nothing more than your trusty rotary drill and a masonry bit—so long as you take care to not burn out the motor of the drill or demolish the bits.
What is the best drill for drilling into concrete?
The best drill for drilling into concrete is one of two tools: A hammer drill or a rotary hammer. They both do essentially the same thing but are different tools. A standard drill or screw gun will work on concrete too but they need to have plenty of torque. A hammer drill has two main functions.
What are the risks of drilling into concrete?
Such activities run the very real risk of damaging a drill bit or accidentally marring the concrete surface in an overzealous, poorly executed attempt at how to drill into concrete.
How to drill through concrete with masonry nails?
Put the tip of the masonry nail at the problem spot and give it a few taps—not hard whacks—with the hammer to break up the obstruction. When you’re done, resume drilling the concrete at a slow speed until you’re sure you’ve passed the rough patch. Periodically pull the drill out to brush away concrete dust.