Table of Contents
How do you clear a forklift error code?
Press and hold the accelerator for 10 seconds or more. Doing so erases the results of the self-diagnostic test, successfully clearing the forklift codes.
How do I reset my Yale forklift password?
Press the star button (*) three times. The star button is located on the right-hand side of the display. Enter the forklift password and press the star button (*). Now that you’re in the service menu, press the 4 or 5 button to go back 1 level if need be.
How do you clear the error code on a Nissan Forklift?
To erase your Nissan forklift codes, the repairs must first be made. Following the necessary repairs, return to Diagnostic Mode. Hold the accelerator down for a minimum of 10 seconds, then release the accelerator and the Nissan forklift codes should be erased.
How do you reset the check engine light on a Toyota forklift?
Battery Disconnecting Technique Drain any remaining electricity. Press and hold the car horn for about 30 seconds to drain any electricity from the vehicle’s capacitor. Wait to reconnect the battery. You’ll want to wait about 15 minutes for the error codes to be deleted and the engine light to turn off.
What does F 16 mean on a forklift?
f16 indicates both directions are sending the same signal to the computer for over 2 seconds..
What does E32 mean on a forklift?
Mitsubishi forklift error codes
Error Code | Explanation |
---|---|
E30 | ECCS C/U error signal |
E31 | Electronic control throttle control error signal |
E32 | Overhear signal (STEP 1) |
E33 | Overheat signal (STEP 2) |
How do you set the clock on a Yale forklift?
How do I reset the date / time on the control panel?
- Light the panel up with the flat of your hand.
- Press the blue menu button enter your pin code and press tick.
- Then scroll down to advanced settings.
- Then scroll right to the bottom of that menu to time and press tick.
How do you reset a Nissan ECU?
Turn the ignition switch to the on position but do not start the car. Count three seconds and then press the gas pedal to the floor and let it up five times in five seconds or less.
What does E24 mean on a forklift?
How to clear forklift error code: Mitsubishi
Error code | Explanation |
---|---|
E21 | Air flow meter error signal |
E22 | Water temperature sensor error signal |
E23 | Throttle sensor error signal |
E24 | Accelerator sensor error signal |